12 May, 2018

LOCOSTO FLASH INTERFACE DRIVER FOR WINDOWS DOWNLOAD

Log to “Flash” tab. SmartMoto will give the message requiring to take phone into boot mode by pressing keys combination: The handset should be detected by SmartMoto as “S Blank Models with boot versions up to 0. To install the driver: Part of phone firmware is reflashed. SmartMoto creates a Temporary Backup File from the handset firmware.

Uploader: Gall
Date Added: 17 July 2015
File Size: 48.75 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 45406
Price: Free* [*Free Regsitration Required]

TestPoint schematics are located at Public Downloads section of www. Alternatively use “Automatic Model Detection” locosto flash interface it will recognize phone automatically. Unmark option loocosto automatically after prepare” and select the appropriate model locosto flash interface SmartMoto list. Niterface handset display will remain blank. SmartMoto creates a Temporary Backup File from the handset firmware.

Do not use locosto flash interface from the battery. Please make sure you do not damage the board We strictly recommend to make a backup of flash from the handset before performing any procedure.

Please disconnect the phone from the cable, remove and insert the battery, switch the phone to boot mode and perform unlock again. Part of phone firmware is reflashed.

Use the TestPoint for each specific phone model and follow the step-by-step instruction strictly. Deep Flash Cable for Xiaomi. Models with boot versions up to 0. Wait till the process finishes. However, in case of any hardware damage or phone warranty termination caused by TestPoint procedure Smart-Clip developer does not bear any responsibility.

Phone doesn’t have to turn on! The handset should be detected by SmartMoto locosto flash interface “S Locosto flash interface Please note that the phone shouldn’t power on until the last stage completed.

SmartMoto Unlocking Manual. Smart-Clip is a professional device for unlocking cell phones.

At this time popup window appears at SmartMoto interface. Log to bookmark “Prepare”. In this case try performing “Master reset” operation and then enter the code again.

Alternatively, the handset can be locosto flash interface using a TestPoint method. If the set stays in Flash mode, phone model has to be selected manually.

After the first Smart-Clip update and account registration at www. To perform locosto flash interface TestPoint procedure the handset requires to be disassembled. Follow the instructions in the schedule, please. In most cases TP contacts are protected by a metal cover, which has to oocosto cut or drilled for TestPoint procedure.

This will enable you to restore the handset to its original state in case of unlock process failure. The handset restarts and can be disconnected.

Please note that with some models there is a single locosto flash interface that should be grounded connected to the metal coverothers have two contacts that should be connected to each other.

The phone enters a flash mode continue with the step 14, please.

The Smart TestPoint v2. MPx models require a driver to be installed.

A – boot versions locosto flash interface from 6. If the phone powers on before Repair procedure completes, repeat whole operation from the beginning. To install the driver: Log to bookmark “Unlock”. Specific procedures for each locoso are provided blow. Do not use hot air fan to remove a metal shield locosto flash interface PCB.

Phone goes into boot mode.

SmartMoto will give the message requiring to take phone into boot mode by pressing keys combination: Enter “zero” 8 times. This can seriously damage the handset. No need to install the phone model driver. If the handset was locosto flash interface to SmartMoto, in boot mode the temporary backup locosto flash interface will not be created. Make sure that phone model and boot version of the phone to be unlocked exactly match the model and boot version stated in the list.

The next steps depend on the phone boot version.

Phone doesn’t power on after that.

About : Jordan

Leave a Reply

Your email address will not be published. Required fields are marked *

Solve : *
3 × 4 =